I will have one as well, please. Pat.

I am in need of a new Tillotson Carb for a older 3W 60 and I also need a recon kit for another Tillotson carb 3w 60. ? ? Pat Cuss.

He has just put his hanging baskets up and needs them for the automatic watering system.

Re: smoke nipple advice Report this post Quote Postby Dave Wilshere » January 28th, 2019, 11:30 pm You cannot put a smoke nipple that close to the flange on a canister set up, it will suck fluid into the engine, foul the plug and reduce power. On the Zimmermann set up you have its designed to have t...

Place the nipple 20 to 25mm from the cylinder exhaust flange and drill a .5mm hole, this will give you good smoke, with smoke fluid or diesel slightly thinned with paraffin. If you need more smoke or your pump is not very powerful go to .75mm hole. smoke works best from half to full throttle only, a...

Two 1/3rd scale WW1 pilot figures needed with or without legs, Phone 01373 864359 office hours. Pat.

From all of the 'West Country Gang' part of Dawn Patrol. Nick, Mikey, Andy, Carlos, Pete, Roy, Pat. Dave was a true friend to us all and will be sadly missed by all, he inspired us and was a wealth of WW1 information. We will remember him for his wit and dedication, his humour and loyalty. Rest in P...

3W 60,s Old short snout type, 10 or 20 year old with single hub ignition magnet, Ideally with ign module, fin condition not important, 3 required minimum . Or / And Zenoah 60,s two required minimum.

Right' this is a real pain, so what I do is go to a paint supplier to the car trade , these are found on nearly all big trading estates, and get 6mm wide 3M 'buff' lining tape. when you mask with this you must press down the edge firmly either with your finger nail or an old blunt kitchen knife ( mu...

It took some serious organising to get the jet liner to fly by at the right moment. Pat.

Congratulations, that low pass picture says it all. Look forward to seeing it in the flesh. Yesterday must have had some 'higher' support as I completed my test flights with my 1/3rd scale Stinson Reliant SR10 and all went very well. We could pair up at the shows, cabin cruisers rule !.

Any good high street photo/print shop with a digital copier will do it. If the plan is an old drawn plan, you cut or fold the plan length ways down the fuz with about an inch over the centreline, get them to copy the larger piece with the appropriate % + dialled in for one half and then get them to ...

Well what can you say, absolutely brilliant.

John, I am truly impressed from one build'a'holic to another, wonderful . Pat.

I think Dave Hayfield has hit the nail, less slots but more in each slot. In dp we are aware that our landings take too long and Ian Redshaw is working on a line astern approach with a land or abort instruction from each pilots spotter when the model is a few feet from the ground. All depends on a c...

Evostik exterior pva is my main glue with extramite in some situations. only sometimes I us aliphatic. never use a non branded glue.'Good thread' .

We are so sad to hear this news, please accept our condolences to Colins family and friends. From all who knew him from this neck of the woods. The west country gang, Pat , Pete, Andy and all the DP gang. Pat Cuss

What is considered appropriate torque on the bolts in this application? Having been a single bolt Zenoah runner for the past 17 yrs without issue........I'm just about to start running a pair of DA's, so I'm now a little concerned!!! Phil I have three DA 150cc motors and not had a problem with eith...