LOL..

That's good to know Dave.. fantastic looking bit of engineering! I have a 1/3 scale model which has a 3/1 reduction unit powered by a Zenoah 62. From memory the scale prop is around 38 inch. The engine is reversed so the prop swings clockwise. Can a unit be manufactured for most engines? will the be...

Hi Dave, is the reduction drive unit manufactured by yourself?

Great to see it finally in the air! any time frame for the paint job?

Any photo's of the project?
I know it still needs painted from our last chat.

Rob.. yes I will be there if you are going down on Sunday.. Will get Gerry and Pheilm (he can buy lunch! LOL)
Just watch the voltage on the servo / RX side of things.
Confirm you are heading and I will show my face.
Cheers.

Looking great! hope this weather holds for the test flight.

August sounds good. Will you do the test up at Ian's site at Causeway??
yes you have to pay your fee each December! TUT TUT! LOL.

lol.. don't know about that!!! but yes I will turn up with a hip flask and plenty of Encouragement. Any idea of when the first flight will be??

Hi John.. yes I still have both models. The plans will go with the kits.
I have the plan for the first Run of kits that Barth done, it's quite different that the current one if you are looking to build one!
C.

Rob.. fantastic to see you back working on this again.. remember to give me a shout when you are putting it through it's test.

I have a partial kit (not much needed to complete) of a Jim Pepino 1/4 Waco ymf[/b] along with the plans and cowl /spats. Kit was cut by Falcon Aviation a while ago.. very good quality wood. It has been started, mainly the tail section but lack of enthusiasm forces me to sell. looking £150 ono.. cow...