just put it in something that will glide really well when it cuts out.........

Here Here.....definately worst engine ive ever tried, as ian says bad for overheating due to design and very small cooling fins, rings tend to sieze up from heat,carb was always in need of tuning to get half decent power,i tried two and worst bit was i bought a second one.....!

i have recently been getting emails from this address saying i have a private message yet when i log on there is nothing..... lma.website.manager@gmail.com <lma.website.manager@gmail.com> message is as follows you have one message from your friend Click To Check Out The Notification ADDRESS IN THIS ...

I wouldn't hold your breath ordering from glens models,ive had some Da 150 reed valves on order for 14 months,after receiving conformation of the order and a handfull of emails later im still waiting.....Wtf

"I am not a fan of the "baffle to death" school of thought as too much back pressure can be created" here here, It is a 2 stroke motor all said and done,as you know they do rely somewhat on back pressure but too much will create heat build up and the motor will run like a dog... ...

Hi ian, Im not sure what motor it is but i would say nearly all ive come across will use one,more so if its a mag because of the pottential to backfire when starting,although the taper will be a tight fit it will prevent you having to re time it if it does backfire/strike as it will spin easier. bes...

thats correct, most strimmer/chainsaws run in the opposite direction to our use so they will run never the less as long as timing is set accordingly,its much easier with an electronic ignition to do but as long as the mount for the mag pickup is close to the flywheel and timed, it will not matter. w...

http://www.agaperacingandhobby.com/

Good link phill...!

Hi, I got my conversion bushings from here http://www.cncengines.com/orderpage.html The conversion bushings will convert the typical zenoah plug to cm6,You will then either have to get 2x resistor cap kits and fit them to the rcexl ignition or use a twin dle ignition or rcexl equivilant (for cm6 plu...

Hi alan,
ports wont match up with the crankcase.
andy

I didnt think you could turn over the reeds because they have offset mounting holes?,if the reed sits open all you have to do is put the heatgun on them briefly to warm them and they will easy to straighten,but it would be harder to pull fuel if the reeds didnt seat correctly,i would say id definate...