New unit fitted and now have full control over the lights, was a faulty unit.

Well had a response from Briancube, looks like a fault on the unit, but have to say what fantastic service , they could not have been more helpful and are sending out a replacement unit.

Brian

U.K. Jet shop in York also stocks ashlock connectors, you can buy just what you need, and very quick delivery.

When I connect my battery for lights the nav lights come on, I've tried resetting them but can't get them to go off, my strobes and landing lights work from my 3 way switch.
Any ideas


Regards Brian

Props arrived very quick delivery,

Many thanks for link, I've ordered some up.

Brian

Hi,
Does anyone know where I can get a 16inch pusher prop. I have searched but cannot find one.


Thanks Brian

Having just read through all of the posts from start to now, what a great thread you have created.
Keep up the great work and look forward to seeing it at one of the shows

Brian

Timing setup and engine running spot on. Getting close to flying it soon.



Brian

Thanks for that Peter, I will set it at 28 and try it.

Regards Brian

Spark problem was ignition unit, just fitted a rcexl unit, anyone know the correct degrees tdc for the engine timing.

Thanks Brian

The giles has a 3w100 twin in it, just found that there is no spark, anyone know how to test the ignition unit on these.

Thanks Brian

Do you use a step battery supply for the servos, rather than just through the reciever, if so what is the best set up

Thanks

Hitec HS-7955TG servos at 6 volt now being installed

Thanks for the replys, only just getting back into model aircraft after 30 years, and having bought this I thought that the servos were under sized so will look to replace them.


Thanks Brian

Hi
Could anyone confirm if hitec servos 545bb has enough power for the wing aileron, I have one per wing fitted, the Gilles is a 1/3 scale 98 inch span with a 3w100 engine.

Thanks Brian