Kalt 22cc advice

Need technical help on some problem? Let us know and we will see what we can do
Frank Skilbeck
Posts: 39
Joined: November 1st, 2017, 9:20 am
Contact:

Kalt 22cc advice

Postby Frank Skilbeck » September 6th, 2023, 7:00 pm

I've acquired a model with an old Kalt 22cc (basically a Zenoah 23cc magneto) petrol engine, initially it wouldn't run so I replaced the rubber bits in the Walbro carb (WT705), it runs now but I can't slow it down. As I reduce the throttle the engine revs drop to just under 3,000 rpm, but then reducing the throttle further sees the rpm increase. At full throttle it's turning a 16 x 8 at just under 7,000 rpm.

Any suggestions?

Frank Skilbeck
Posts: 39
Joined: November 1st, 2017, 9:20 am
Contact:

Re: Kalt 22cc advice

Postby Frank Skilbeck » September 13th, 2023, 8:06 pm

Turned out to be a gasket problem not sealing the carb to the engine, allowing air in, made up some new gaskets and it's running well now with a steady low tickover, now if I could just find a way to cheaply quieten it down it would be a good engine.


Return to “Technical Help required”

Who is online

Users browsing this forum: No registered users and 1 guest