Large Model Association Forum

Hi again,

In the absence of the marvellous Graupner flap hinges, does anyone know of a source ? For a 30% Wilga, so I might just end up designing something to get cnc routered, but why re-invent the wheel?

Also, anyone know of jobbing engineers friendly to this forum, I need some bits made for the undercart?

Many thanks, Elliot.

Any good?

https://nexusmodels.co.uk/products/offs ... DOXJ7jdcME

Thanks Peter, but those are tiny- for doors.

Ok, these are much bigger

https://www.lindinger.at/en/AIRPLANES/A ... cs/9782385