Page 1 of 1
Which servos
Posted: April 11th, 2010, 6:42 pm
by adrian west
Hi could someone point me in the right direction as to which servos to use in a DB 80inch spitfire mainly for elevator and alerons
regards adrian (am using 2.4 spectrum)
Re: Which servos
Posted: April 12th, 2010, 6:23 pm
by Matt Harrowven
adrian west wrote:Hi could someone point me in the right direction as to which servos to use in a DB 80inch spitfire mainly for elevator and alerons
regards adrian (am using 2.4 spectrum)
The worlds your lobster on this, but my choice would be Hitec 645mg's. I use these in my 81" P47, one on each ele half and one per aileron.
Everyone has there favorite make/type, I'm sure peeps will be along with theirs.
HTH
Mat
Re: Which servos
Posted: April 12th, 2010, 7:20 pm
by Bob Thompson1894
Another vote for 645mgs. Excellent powerful 'cooking' servos.
Re: Which servos
Posted: April 13th, 2010, 10:04 pm
by stuart cotgrove
following on from Matt's and Bob's advice, I too use 645mgs. They were in my 88" DB Hurricane and currently in my 30% Chilton, 33% Pup and are/were faultless.
Re: Which servos
Posted: April 14th, 2010, 4:30 pm
by adrian west
Thanks for the replys think ill go with them then
cheers once again adrian