Large Model Association Forum

Hi All
i am aproaching the installation of the servos in this biggy
the 1985 plan says to fit the 2 elevator servos in the middle to front location of the fuz.
the Lma inspector advised that i fit the servos into the stab, but have read on several forums that
this would cause a c of g issue please can any one help as i am totally confused
many thanks

Paul

Paul---i would take the advice of your inspector---there is far less chance of any backlash /slop/flutter if you put short linkages direct to the elevators,i have set up and flown several of the Zirolli DC3,you will need a good chunk of lead up front for balance anyway,so a little more to counterbalance the servos wont be a problem---best of luck with the rest of the build---DAVE

think of the weighty push rods you wont be using, short 2 heavy duty arms, 2x 3mm pushrods, 2 ball links, 2 kavan 3mm clevises work for me,

Thanks guys for the advice very helpfull many thanks
P :0)

I'm going to write an artical on this one for the journal.