Page 1 of 1
Bucker Jungmeister C of G
Posted: July 28th, 2009, 8:15 am
by alanrhilton
I bought a 1/4 scale Jungmeister at the Hastings show over the weekend .Looking over the model it seems unflown. I don't have a plan so the correct C of G position is unknown.The model is based on D-EVEO which has an inline engine. Can anyone help please.
Alan
Re: Bucker Jungmeister C of G
Posted: August 24th, 2009, 7:57 pm
by Arthur Fielding
Hi
Have only just seen your request, but this may help.
I have built the model that you inquire about and the plan shows the CG point 7ins back from the centre section leading edge of the top wing ( thats about on the top wing rear bolt fixing point.)
Good luck. Arthur.
Re: Bucker Jungmeister C of G
Posted: August 28th, 2009, 11:01 am
by alanrhilton
Thanks Arthur