Zenoah 38 Problems

Need technical help on some problem? Let us know and we will see what we can do
Post Reply
Steve McDonald
Posts: 53
Joined: December 6th, 2008, 9:56 am
Location: Ross-shire, Scotland

Zenoah 38 Problems

Postby Steve McDonald » January 29th, 2017, 4:19 pm

I changed the carb diaphragm on my Z38 and cannot get it to run, it would appear to be flooding the engine. When I remove the spark plug fuel pours out, I dry the plug off and it fires and starts but won't run for long and will not restart without the same rigmarole again. Not aware of doing anything wrong when changing the diaphragm. Any pointers or suggestions would be much appreciated.
Top
Dave Wilshere
Posts: 78
Joined: October 18th, 2013, 7:55 pm

Re: Zenoah 38 Problems

Postby Dave Wilshere » January 29th, 2017, 9:33 pm

Did you ensure the pin groove on the diaphragm is in the fork . I'm guessing its on top

Dw
Top
Steve McDonald
Posts: 53
Joined: December 6th, 2008, 9:56 am
Location: Ross-shire, Scotland

Re: Zenoah 38 Problems

Postby Steve McDonald » January 29th, 2017, 10:21 pm

Dave Wilshere wrote:Did you ensure the pin groove on the diaphragm is in the fork . I'm guessing its on top

Dw


Dave,

Thanks for the reply, I thought i done like for like when I was fitting it, I will check it out.

Cheers

Steve
Top
Dave Collis 2296
Posts: 115
Joined: December 4th, 2008, 4:13 pm
Location: Pitt Meadows, B.C. Canada

Re: Zenoah 38 Problems

Postby Dave Collis 2296 » January 30th, 2017, 3:28 am

Also make sure the gasket goes on the carb first then the diaphragm then the cover.

Cheers,
Dave.
Top
Post Reply

Return to “Technical Help required”

Who is online

Users browsing this forum: Bing [Bot] and 43 guests