Evolution 80 cc

Need technical help on some problem? Let us know and we will see what we can do
Neil grant
Posts: 8
Joined: October 24th, 2017, 7:52 am

Evolution 80 cc

Postby Neil grant » May 10th, 2018, 7:47 pm

Hi can anyone help me what should my evolution be turning a wooden 27x10 prop at on the ground thank you Neil 07702860897

steve stuttard
Posts: 38
Joined: January 4th, 2009, 7:40 pm

Re: Evolution 80 cc

Postby steve stuttard » May 21st, 2018, 2:10 pm

anti clockwise round and round !!!!!!!

Tony Collins 1073
Posts: 750
Joined: December 6th, 2008, 10:00 am
Location: Braintree. Many Miles from any "Large Model" club

Re: Evolution 80 cc

Postby Tony Collins 1073 » May 21st, 2018, 2:41 pm

Neil, this taken from the manual and elsewhere may help you.

The Evolution 80GX has been designed to generate maximum power
at 6200–6600 rpm, according to the type of exhaust used. If you
wish to utilize the maximum power output, choose a propeller which
will allow the engine to reach these revolutions, or slightly lower
revolutions. (The engine will unload in the air, depending on the
aircraft speed and propeller selected.)
Choose your propeller according to the chart and to achieve
approximately 6400 rpm on the ground for best performance and
the lowest noise signature

80 GX Two Blade.....26x10. 26x12. 27x10.

Apparently swings a 2-blade Mejzlik 27 x 10 at 6200 rpm

Steve, people come on this forum for help, not to have the p... taken out of them.

Return to “Technical Help required”

Who is online

Users browsing this forum: No registered users and 4 guests