Large Model Association Forum

hi all i have mange to source a kill switch for magneto and works great and kills the engine dead on my chippy but i do have mixed with the throttle using mr hayfields mag kill

i am looking to do this again on my z80 twin if has eazy start on it, twin coils i am not sure where to cut into the red side

and where to earth,

i did think of a cdi conversation kit, but 4£ against £100, wins the day

can anyone help please?

no need to mix it in with your throttle but you could put a inline failsafe instead of using a mag Killswitch I would have just put a servo on your chuck instead

I'll have a look at my 80 a twin with a easy Start on it

thank Arthur

i need to study this for a while, before i make any cuts and joints