Page 1 of 1
correct plugs for weslake 342
Posted: November 14th, 2009, 1:41 pm
by Dave Collis 2296
Good day gentlemen.
Can someone enlighten me as to the correct plugs for the above engine? When I acquired the engine, there were no plugs supplied.
Cheers, Dave.
Re: correct plugs for weslake 342
Posted: November 14th, 2009, 2:17 pm
by Tony Collins 1073
Hi Dave, The original plug fitted to the 342 Weslake is the Bosch R10 resistor plug although similar types can be fitted.
The main consideration is the resistance reading through the plug which ideally for best interference control is a minimum of 8K ohms.
Give my regards to Mike Clemmens if you ever run into him.
Tony Collins 1073
Re: correct plugs for weslake 342
Posted: November 14th, 2009, 9:13 pm
by Dave Collis 2296
Thank you, Tony. As it happens I was talking to Mike on the phone a couple of months ago regarding props for my 3W 200.
Cheers, Dave.