Toni Clark 30% Sopwith Pup engine fitment
Posted: January 29th, 2021, 4:13 pm
by Mick Black
Hi all has anyone built the Toni Clarke Sopwith Pup with the Zenoah with reduction gear. I have a picture from Toni Clark but when I fit it in the same position mine is 15mm to high. To lower it I would have to cut the cowl. Just wondered if anyone had solved this problem.
Re: Toni Clark 30% Sopwith Pup engine fitment
Posted: January 29th, 2021, 4:17 pm
by Mick Black
- BAFAD219-79A1-47D0-A225-49A60CED260E.jpeg (244.03 KiB) Viewed 3605 times
Re: Toni Clark 30% Sopwith Pup engine fitment
Posted: February 6th, 2021, 7:25 am
by Peter Smedley
https://toni-clark.com/bilder/galerie/b ... index.htmlLooks like the ignition module sit around 5 o’clock...and the cowl is cut for it