Page 1 of 1
Control Throws - 1/4 Scale Jerry Bates Chipmunk
Posted: March 22nd, 2021, 8:58 pm
by Mike Whitehead
Hi All,
Firstly I hope your all safe and well.
I'm looking for some advice please. I'm building a 1/4 Scale Jerry Bates Chipmunk but I can't find any details on the plans for the control throws. Anyone built one or have access to the information?
Any help appreciated.
Mike
Re: Control Throws - 1/4 Scale Jerry Bates Chipmunk
Posted: March 23rd, 2021, 2:08 pm
by Alan Cantwell 1131
Ask the man hiself Mike,
http://jbplans.com/shop/.
Re: Control Throws - 1/4 Scale Jerry Bates Chipmunk
Posted: March 23rd, 2021, 9:38 pm
by Mike Whitehead
Thanks Al, good call, question sent via JB website. I’ll let you know when/if I get a reply.
If anyone else has the answer though, your help would be appreciated.
Re: Control Throws - 1/4 Scale Jerry Bates Chipmunk
Posted: October 30th, 2021, 4:22 pm
by Mike Whitehead
I never got a response from JB, however there are lots of these around so surely someone could offer their set up advice?
Appreciated
Mike
Re: Control Throws - 1/4 Scale Jerry Bates Chipmunk
Posted: October 30th, 2021, 9:51 pm
by stuart knowles 1611
I can't give you measurements but on mine, Elevator and rudder are not critical. I have remodelled the aileron hinges to try and get more movement as the roll rate was pretty s l o w. So as much as possible and with differential
Re: Control Throws - 1/4 Scale Jerry Bates Chipmunk
Posted: November 14th, 2023, 1:08 pm
by Michael Hollingworth
Mike.
Are you on FB ?
Will message you there.
Thanks Mike.