Large Model Association Forum

Hi
The on /off switch on my JR RD 922 power save Rx got its self broke ( don't ask) .now the manual tells me that I can not use a normal switch cos its wired differently. Now the plug is a standard three pin servo plug, but only two wires come out of the on/off switch , both are black. My question is how do I wire a new switch ?
Thanks for your time
Arthur.

Looking at the diagram, the switch connects the 2 black wires to each other when ON as the batterys connect directly to the Rx and not via the switch.
http://www.jramericas.com/manuals/JRPR922-Instructions.pdf

Thanks for the reply, but still not sure.
I have a plug with plus, minus and signal wires ,one of these wires goes to the switch and then back to another wire at the plug. But I do not know which wires to use.
Hope you can help
Thanks
Arthur

I have had a read on other forums, apparently the Rx is turned off by connecting the 2 wires together, at the Rx it is the 2 outer pins that are used.

That's quite right, the PowerSafe switches short the outer two connectors on the servo plug together to turn the receiver off.

If adapting a normal switch, you need to connect the signal and earth wires together with the switch to turn off, disconnect them to turn on.

Thanks for all the advice, the Rx is back on line.
Like a lot things its simple when you know how.
Regard's
Arthur