Page 1 of 1
futaba 9 VAP stick mode change
Posted: September 30th, 2009, 8:30 am
by frederick barlow
does any one know how to change the stick mode form mode 1 to mode 2 on the futaba 9 vap there is no mention in the instruction booklet on how to do it and i had a look inside and cant see any plugs just lots of grey wires and lots of pcb any hints woukd be apriciated
Re: futaba 9 VAP stick mode change
Posted: September 30th, 2009, 5:40 pm
by Alan Cantwell 1131
strictly an engineer job, the sets are not mode switchable, just switch the throttle ratchet over, and you will be in all sorts of bother
Re: futaba 9 VAP stick mode change
Posted: October 1st, 2009, 10:35 am
by frederick barlow
do you know any engineers? i got it for 2.4 its as new and not a lot of use to me
Re: futaba 9 VAP stick mode change
Posted: October 1st, 2009, 5:10 pm
by Simon Willey
Do Ripmax not do this service, I know I used to send my 9zap to them for servicing .
Simon
Re: futaba 9 VAP stick mode change
Posted: August 13th, 2010, 11:07 am
by Mike altham
Even if it is an old topic I sent mine to Mike at modelradioworkshop.co.uk
Very good and alot cheaper than ripmax.
Cheers,
Mike.