Howard Pete
Posted: September 21st, 2022, 2:24 pm
Hi guys I’m thinking of selling my Howard Pete model built from the David Anderson plans .
It is 1/3 rd scale - which makes it 80” span ,powered by a 25cc Roto engine bought new for this model.
All servos on surfaces are Hitech 645 except throttle.
Ready to fly with JR receiver installed
New spinner which cost £60 as the right size.
Covered with Oratex and sprayed white with cellulose
Flies very well
Asking £475 ready to fly - this is quite a large model
Email sigginsc@aol.com or ring 01332 811546.
I can’t load photos at present but can email if required
It is 1/3 rd scale - which makes it 80” span ,powered by a 25cc Roto engine bought new for this model.
All servos on surfaces are Hitech 645 except throttle.
Ready to fly with JR receiver installed
New spinner which cost £60 as the right size.
Covered with Oratex and sprayed white with cellulose
Flies very well
Asking £475 ready to fly - this is quite a large model
Email sigginsc@aol.com or ring 01332 811546.
I can’t load photos at present but can email if required