It will let you know beforehand in case there is anything of interest.
If you have an interest in any particular item you wish to consider , please drop me an email
at hangar4@talktalk.net
- DSCF0621.jpg (188.66 KiB) Viewed 864 times
- DSCF0622.jpg (198.3 KiB) Viewed 864 times
This a high end fret saw which can take that standard small blades but for heavy work can use
junior hacksaw blades. It has a variable speed controller operation from zero to maximum.
- DSCF0624.jpg (205.34 KiB) Viewed 864 times
- DSCF0625.jpg (207.04 KiB) Viewed 864 times
- DSCF0626.jpg (211.59 KiB) Viewed 864 times
Two very nice Weslakes 342 cc engines . Some of you may know that I have rebuilt a lot of these engines
since 1999.
They both have exhaust manifolds which have been faced to fit the exhaust ports accurately.
No gasket should be used when fitting. Only high temperature Silicon. This prevents the Exhaust flange
bowing as the gasket compresses at either side. and eventually breaking down.
This ensures a good long lasting reliable joint
Because the original weslake mounting plates were prone to cracking I have custom built !0mm heavy duty
mounts that I guarantee will never break. They have 19 mm holes for the mounting rubbers.
One of the engines has an original works manufactured 120mm prop extension.Once again very rare.
- DSCF0627a.jpg (201.39 KiB) Viewed 864 times
A new unused westlake 342cc crankshaft. Not easy to come by.
- DSCF0619.jpg (193.93 KiB) Viewed 864 times
Some really heavy duty wind up ramps. Very unusual. Never used.