Large Model Association Forum

I'm after a short (about 30mm long) prop driver for a Zenoah 62, has anybody got one lying about unloved?

Thanks
Rob

Hi Rob, I'm pretty sure I have a new one. I've just got in off nights so Ill take a look this afternoon when I get up. If I have one its yours FOC.

Simon..

Hi Rob, shortest I have is 40mm. If its any good PM me your postal address and Ill pop it in the post.

Simon.

Simon,
Thanks very much for looking and for the offer, but I need a shorter one really. I've got a 50mm driver at the mo and it's a good inch too long!
Thanks
Rob

No Worries, Hope you get sorted..

I have a z62 with I believe the shorter driver and need the longer one. If mine is the correct size (I'll measure it later) would you be interested in a straight swap for your longer one. Regards karl

I've just measured mine and it's 38mm.
Regards karl

Karl, It's probably too long, but I'll do you a swap anyway as I've got a couple of the 50mm ones. PM me your address and I'll stick one in the post.

Pm sent mate. Thanks

Hi Rob,
Are Zenoah drivers all the same, i.e. 38 & 62? I've a feeling that this came off a Z38. Will it fit yours?

Stuart,
The bolt holes in the back flange are 6.75mm diameter and the centres are 46.25mm apart. The back flange is 57.9mm diameter
The hole in the centre is 21.8mm diameter
The prop bolt hole is M10

It might be the camera angle but the one you've got looks a bit different to that

Thanks

Rob

I'll go have another look

If its not the same then a blind man riding past on a galloping horse wouldn't notice the difference.

I could bring it to the AGM if you are interested. Let me know if you want to try it.
cheers
stu k

Stu, Aye if you could bring it to the AGM I'll bring a 62 mag to try it on

Thanks

Rob

OK will do

I have one.