Large Model Association Forum

I need another carburettor- industrial or otherwise for my zlin 526. Can anyone suggest a Walbro WT model suitable
for 35cc to 38cc engine that includes a choke. The original carb is priced around £50 to £60 and
I feel that there must be something less expensive to be had.
The venturi is 13.49mm but something very close would probaby be OK.
Any suggestions would be greatly appreciated.
Cheers Tony.

I use these Tony- http://www.ebay.co.uk/itm/CARBURETTOR-C ... 1262186364?

That was quick off the mark Bob...might have known I could rely on you to help me out AGAIN
Cheers mate,all done and dusted.
Tony.

I have used a hobbyking carb for about 4 years on my roto 25 worked for me.
https://hobbyking.com/en_us/replacement ... ngine.html

Zenoah carbs are way overpriced. Not tried the Hobbyking ones but myself and Brian King are using the ebay ones and they just work, no fuss. I cut off the bit of casting that holds the stop screw and dump that. Its just about as cheap as a carb gasket set.