Large Model Association Forum

Folks, I hope you don't mind but I asked Rob Buckley if it was OK to advertise my new business!
http://www.carbercomposites.com has been launched online! We have produced designs and made available 3D printing and moulding of R/C model aircraft accessories that previously were not readily available. Yes we have all made exhaust stacks, guns or drawn on or used decals to show your fuel caps! For this very reason I decided to have a go at making these easier for me by designing them and producing them in almost any scale! This has developed into me and my good friend Bert Scmitz setting up Carbercomposites. Please visit our website to see if we can help you with your scale printed parts. From simple fuel caps to exhaust stacks, gun ports to WW1 Spandau, Vickers and Lewis guns! Add scale detail to your flying pride and joy!

Thanks and I hope you like the site!
Cary

well done

Well done Cary. How feasible would a Mercedes DIIIa engine at 1/4 scale be for my Albatros DVa?

Cary, hope it all goes well.

Bob, I found the "Avon hand cream" bottles are the exact diameter for the Merc Diii cylinders! (Wife couldn't work out how she was using so much!)

Steve (soft hands) Mansell

Hi Bob, I will send you a PM & we can discuss over the phone!
Cary

Richard, thanks it is appreciated
Cary

Steve, thanks it is appreciated
Cary