Seagull models Westland Lysander.
Posted: September 25th, 2018, 2:58 pm
Seagull models Westland Lysander.
Span 118Inches.
Two years old with the following spec:
Servo’s:
Elevators and rudders: JR NX3421 serial bus mini digitals
Ailerons : JR579’s.
Flaps: Hitec 635 Hb’s
Tail wheel steering: hitec 654 mg.
Throttle: Hitec 322 Hb.
Two 6v 5000 mAh NiMH batteries
Ashlock connectors on wings and tail planes
Futaba R7018SB powersafe sbus 18 channel receiver.
JR heavy duty ignition switch.
Rexcel opto isolator
Dubro re-fulling valve and 20 oz Dubro tank
Dubro Low bounce wheels
A Lysander specific spinner.
The model is not new. It has had a couple of covering punctures to the underside of the wings caused by debris on the field which have been properly repaired and painted, (Paint is not an exact match). There is a minor ding to the fuselage underside which has been sorted but didn’t need painting and the cowl has a few bits painted in where the original paint literally came off. The cowl is baffled for a Saito 60R3 radial which IS NOT included.
A lovely scale flying model.
Willing to drop price to 500 and remove the receiver, also would be interested in part ex for a Boomerang Elan, Torus or Excalibur +.
https://www.youtube.com/watch?v=w4u_dvBvEZo
Tel 07547679779
E-mail charliecox1011@gmail.com
Span 118Inches.
Two years old with the following spec:
Servo’s:
Elevators and rudders: JR NX3421 serial bus mini digitals
Ailerons : JR579’s.
Flaps: Hitec 635 Hb’s
Tail wheel steering: hitec 654 mg.
Throttle: Hitec 322 Hb.
Two 6v 5000 mAh NiMH batteries
Ashlock connectors on wings and tail planes
Futaba R7018SB powersafe sbus 18 channel receiver.
JR heavy duty ignition switch.
Rexcel opto isolator
Dubro re-fulling valve and 20 oz Dubro tank
Dubro Low bounce wheels
A Lysander specific spinner.
The model is not new. It has had a couple of covering punctures to the underside of the wings caused by debris on the field which have been properly repaired and painted, (Paint is not an exact match). There is a minor ding to the fuselage underside which has been sorted but didn’t need painting and the cowl has a few bits painted in where the original paint literally came off. The cowl is baffled for a Saito 60R3 radial which IS NOT included.
A lovely scale flying model.
Willing to drop price to 500 and remove the receiver, also would be interested in part ex for a Boomerang Elan, Torus or Excalibur +.
https://www.youtube.com/watch?v=w4u_dvBvEZo
Tel 07547679779
E-mail charliecox1011@gmail.com