Page 1 of 1
SOLD 74" 1/6th Scale P51 Mustang ARTF
Posted: August 7th, 2020, 7:23 am
by Ron Wylie
SOLD - Lovely Mustang P51, 74" (Possibly Pica Enterprise kit ?) with ASP 108 2 Stroke engine which feels really smooth with lots of compression. Concealed muffler. Air retracts which have not been used and are "blanked off" ( for some reason) . Retract tail wheel. All servos and 35Mhz RX. Will need new flight battery. In nice condition with a few hangar "dings" but no structural damage. Very nice model. £300 OVNO. Can meet at reasonable distance from Grimsby but must observe Social Distance.
Re: 74" 1/6th Scale P51 Mustang ARTF
Posted: August 7th, 2020, 4:40 pm
by ian redshaw
Hi Ron, when you say blanked off, do you mean the wheel wells have been covered over like in your photo of the underside? I hope not as these look like the scale doors present on a Mustang, have you tried opening them?!!
Ian.
Re: 74" 1/6th Scale P51 Mustang ARTF
Posted: August 7th, 2020, 6:04 pm
by Ron Wylie
Hi Thanks for your information. I have knowledge of air retracts and not the equipment to try them, so I have desctibed them in the best way I can and let any potential buyer decide. Thanks again
Re: 74" 1/6th Scale P51 Mustang ARTF
Posted: August 7th, 2020, 6:05 pm
by Ron Wylie
sorry that should be no knowledge and I could do more damage, Best to let those that know deal with it!
Re: 74" 1/6th Scale P51 Mustang ARTF
Posted: August 8th, 2020, 5:34 am
by Ron Wylie
On further examination, Ian is correct (thank you Ian). These are not blanking plates they are part of the retract system. There are 2 servos which lower them (used a servo tester) thus allowing the wheels to retract into the wing. Very clever. So I retract (no pun intended) the statement that they are "blanked off". Now worth more money?
Re: 74" 1/6th Scale P51 Mustang ARTF
Posted: August 9th, 2020, 8:51 am
by Cary Bailey
Hi Ron, with all the gear working the model is worth £300 all day long!
Cary