Page 1 of 1
Z62 Reduction drive Wanted.
Posted: September 15th, 2020, 9:12 pm
by tim.mock
Would anyone have a reduction drive unit for a Zenoah 62 that they would like to sell ? I already have an engine ready for conversion.
Many thanks.
Re: Z62 Reduction drive Wanted.
Posted: September 16th, 2020, 9:08 am
by ian redshaw
Hi Tim, which reduction drive are you after? Reeves Torquemaster (I think 1 to 1.75) and the Schlundt (about 1 to 2.9) are the ones I know of. I'm pretty sure I have a spare Torquemaster.
Ian.
Re: Z62 Reduction drive Wanted.
Posted: September 16th, 2020, 5:55 pm
by tim.mock
Ian
I only know of the Reeves and Tony Clark units that I think are both the same reduction. Yes the torque master would be good. Please let me know how much you would like for it.
Re: Z62 Reduction drive Wanted.
Posted: September 17th, 2020, 7:21 am
by ian redshaw
Hi Tim, the Toni Clark units are for the Zenoah 38, though they did sell the Schlundt units for the Zenoah 62 but they aren't on their website that I can see. The Schlundt units are very similar to the TC Zenoah 38 units. I'll have a root for the Reeves Torquemaster at the weekend.
Ian.
Re: Z62 Reduction drive Wanted.
Posted: September 21st, 2020, 8:18 pm
by ian redshaw
Hi Tim, I do have a 'spare' Torquemaster but is only good for spares as I've robbed some bits for another. Apologies for getting your hopes up perhaps, Ian.
Re: Z62 Reduction drive Wanted.
Posted: September 27th, 2020, 4:57 pm
by tim.mock
Thanks for looking Ian.
Might also be looking for a reduction drive for a Z38 for a different project if you know of one?
Regards
Tim