Calculating the required servo power

Any topic that is not suitable for the other topic items
John Greenfield
Posts: 358
Joined: December 5th, 2008, 2:08 pm
Contact:

Calculating the required servo power

Postby John Greenfield » May 10th, 2012, 12:15 pm

All

just found this useful little site that will calculate the required servo torque for any specified control surface.

http://translate.googleusercontent.com/ ... PaCL1fMgdA

Just remember that the result will only be as good as the data you put in !!!

John

Barry Bennett
Posts: 37
Joined: December 4th, 2008, 2:15 pm
Contact:

Re: Calculating the required servo power

Postby Barry Bennett » May 14th, 2012, 7:43 pm

Seems to calc.OK. I used some values for two calcs, just changing the speed from 50 to 100 and the force was four times, as expected.
Thanks for that John.


Return to “General Discussion Topics”

Who is online

Users browsing this forum: No registered users and 7 guests