Calculating the required servo power

Any topic that is not suitable for the other topic items
Post Reply
John Greenfield
Posts: 424
Joined: December 5th, 2008, 2:08 pm
Contact:
Contact John Greenfield

Calculating the required servo power

Postby John Greenfield » May 10th, 2012, 12:15 pm

All

just found this useful little site that will calculate the required servo torque for any specified control surface.

http://translate.googleusercontent.com/ ... PaCL1fMgdA

Just remember that the result will only be as good as the data you put in !!!

John
Top
Barry Bennett
Posts: 37
Joined: December 4th, 2008, 2:15 pm
Contact:
Contact Barry Bennett

Re: Calculating the required servo power

Postby Barry Bennett » May 14th, 2012, 7:43 pm

Seems to calc.OK. I used some values for two calcs, just changing the speed from 50 to 100 and the force was four times, as expected.
Thanks for that John.
Top
Post Reply

Return to “General Discussion Topics”

Who is online

Users browsing this forum: No registered users and 1 guest