Large Model Association Forum

Having recently come into a quantity of metal work tooling, I'm struggling to find out exactly what this is (Dum question maybe, but I'm not a machinist & have never seen one of these before)

Can anyone help?

Thanks

Phil

Its a vertical milling slide Phil, on your crosslide, you will find some T slots, these take the T slot nuts you see in the picture,
On the side facing down, the milling table face, are the work mount T slots, these take clamping bolts, that clamp the work to the table, the workpiece can be orientated to the desired angle required by undoing the 2 hex nuts you can see, there are 2 sets of these, both can be altered by degree,
The myford is quite a decent bit of kit, the boxford was by far the more superior lathe, but they never developed the amount of accesories myford did,

Wot else you got?.

Thanks Alan....figured you'd know!!!

Slowly getting things on eBay.............

Lathe (in need of TLC) - http://www.ebay.co.uk/itm/261615064341?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649

125mm 4 jaw - http://www.ebay.co.uk/itm/261619333088?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649

100mm 4-jaw - http://www.ebay.co.uk/itm/261619354302?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649