Large Model Association Forum

Hi All,
Fitting out a 1/4 Nieuport 28 using 2.4 Frysky receiver. This model has LOTS of metal wire braces both in fuselage and of course all the wing bracing wires. Any suggestions re mounting of receiver to avoid any interference/ range problems would be appreciated. Never had any problems with these receivers before but not not used 2.4 in this type of model.
Regards
Edgar

I think T9 Hobbies still sell the Rx aerial extensions for the FrSky Rx. I have used them on a cople of models and they have proved very good. The Rx can be put somewhere convenient and the Rx whiskers are then placed out of any potential interference

I don't know if you are using FASST
http://www.t9hobbysport.com/frsky-receiver-antenna