New project No 3- jodel robin regent

[richard armstrong]

3rd project for refurbishment

1/4 scale Robin Regent

few minor issues like the canopy is cracked and needs fibre glassing inside to stabilise

2 batteries need replacing, tank needs an overhaul and check over new clunk and tubing

2 rx set up again

to my surprise it has a twin 80cc Zanoeh with easy start,

is there anything i need to know about the 80cc twin?

DSCF1067crop.jpg (236.37 KiB) Viewed 9974 times

DSCF1068crop.jpg (122.56 KiB) Viewed 9974 times

[chris-berry]

Where do you get all these models from Richard? They all seem quite nice but all need some work.

[richard armstrong]

i got them as a job lot last year

they where all flyable, i like to go through them, check everything over
clean the tanks check servos change batteries, etc,

just to be safe

i just don't want to lose any

a couple was in storage for a year unused the tanks need replacement

the tank on the robin needs overhauling and a few minor paint touch up

[chris-berry]

What span is the Jodel?

At 1/4 scale that'll make it about 7ft". With an 80cc up the front its either heavy or way over powered.

[richard armstrong]

What span is the Jodel?

At 1/4 scale that'll make it about 7ft". With an 80cc up the front its either heavy or way over powered.

bit of both
not sure which kit this is

need a new 22oz dubro tank but funds are very tight

101" wing

6-6ish on the fuse

think it might be a ESM kit, but not sure, its fibreglass and built wing i am hoping to have this one ready for Elvington for static at elvington possible test flying.....?????????

[Rob Buckley]

Buy a new bung and clean the rest off, the HDPE will be ok.

[richard armstrong]

Buy a new bung and clean the rest off, the HDPE will be ok.

i have a new bung but the cap and plate are cracked so will reused the old tank as a smoke tank and play safe

£6 is nothing

[Rob Buckley]

Depends how tight funds are!

[chris-berry]

It could be an airworld kit with that span?

[richard armstrong]

Depends how tight funds are!

tight but not that tight but if i can find another hanger 9 tank cap and plate 20/22oz tank i will be able to reused the original tank, i have the petrol bung and tubing

[richard armstrong]

It could be an airworld kit with that span?

possible but looking at the ESM kit its leaning more that way i think i have found the manual for it?

i just found a 1/3 scale version which is sweet as a nut for a tow plane

https://www.youtube.com/watch?v=tFolRQMlxAc

just wondering if its worth adding a tow point? probably not at this time?

[chris-berry]

I think you'd be best off doing some flying first Richard before attempting to tow!

[Alan Cantwell 1131]

Its nice, but its not a esm kit

[richard armstrong]

Its nice, but its not a esm kit

so which arf kit is then Alan?

if i know that then i can find the surface throws measurements in a manual

[richard armstrong]

I think you'd be best off doing some flying first Richard before attempting to tow!

chris i just thinking allows

i've done my first solo last week so i am hoping to keep going

[Bob Thompson1894]

not bad in...five years? At that rate you'll be towing by 2050.

[paul hughes]

Ihave been watching this thread with interest and know exactly which model that is, as i had one myself and i still have the information sheet that came with it. By the way it should have GRP wheel spats, but i guess your not bothered about that.

[Alan Cantwell 1131]

Ive no idea Richard, it certainly wasnt around when i worked with YT, and isnt, as far as i know, a new release, Paul seems to know though

[richard armstrong]

Ihave been watching this thread with interest and know exactly which model that is, as i had one myself and i still have the information sheet that came with it. By the way it should have GRP wheel spats, but i guess your not bothered about that.

thanks paul, pease can u send me a copy of the info sheet i need to set up the surface throws?

yes should have spats but they just get in the way, it did not come with them?

[richard armstrong]

not bad in...five years? At that rate you'll be towing by 2050.

by then bob i might have my A cert at least LOL