Angled petrol fittings **NOW FIXED UP THANKS**

[Steve Vodrey]

I am struggling to get some right angled fittings to vent my square SLEC fuel tanks I am fitting to a model from the underside. The straight ones will not do the job.
Any ideas where to get them?
Steve Vodrey

[Rob Crawford]

Specifics: are they threaded or do they push through a bung?

[Steve Vodrey]

Thanks Rob the fittings are threaded. They need to be fitted to the top to maximise the tank capacity.
I need the vent pipes to run forwards across the top of the tank.

Resized tank.jpg

[Steve Perry]

http://www.ebay.co.uk/p/set-of-5-norgren-enots-4-3mm-x-m5-elbow-push-on-fitting-27133419/1150409663?_trksid=p2047675.l2644

[Steve Vodrey]

Almost there with the last.
What I need looks like this...

typical fuel tank.jpg

See the angled fittings

[Steve Vodrey]

Fixed up now.
After extensive research Tettra 4207 3mm 4mm right angled nipple fittings do the job.
They are available from Japan through Amazon.

413vKtNTudL._SS160_.jpg

[Cary Bailey]

Fixed up now.
After extensive research Tetra 4207 3mm 4mm right angled nipple fittings do the job.
They are available from Japan through Amazon.

413vKtNTudL._SS160_.jpg

Steve, you can get them from Propguy as they are fitted to his range of fuel tanks
Cary

[Rob Crawford]

Glad you got it sorted.

That graupner is a nice tank isn't it

[Dave Wilshere]

Just for future reference the one you showed are Miniature Aircraft USA angled tank fittings.
https://www.miniatureaircraftusa.com/mi ... itting-set

(The Graupner tank 272 is 1ltr) The nalgon bottle is used by several manufacturers.

[Steve Vodrey]

Thanks Dave.
I managed to get the pic from Google Images but hand idea who did them.
Good for future reference.

[Dave Wilshere]

Just as an FYI I have some of the Tettra 90 degree fittings too...

[Kevin Fairgrieve]

I know you are sorted now, but I came across these tanks.

Might prove useful for future reference.

http://www.aeroplusrc.com/ACCESSORIESPR ... duct_id=28

Kev