Large Model Association Forum

I am struggling to get some right angled fittings to vent my square SLEC fuel tanks I am fitting to a model from the underside. The straight ones will not do the job.
Any ideas where to get them?
Steve Vodrey

Specifics: are they threaded or do they push through a bung?

Thanks Rob the fittings are threaded. They need to be fitted to the top to maximise the tank capacity.
I need the vent pipes to run forwards across the top of the tank.

Almost there with the last.
What I need looks like this...



See the angled fittings

Fixed up now.
After extensive research Tettra 4207 3mm 4mm right angled nipple fittings do the job.
They are available from Japan through Amazon.

Steve Vodrey wrote:Fixed up now.
After extensive research Tetra 4207 3mm 4mm right angled nipple fittings do the job.
They are available from Japan through Amazon.

413vKtNTudL._SS160_.jpg

Steve, you can get them from Propguy as they are fitted to his range of fuel tanks
Cary

Glad you got it sorted.

That graupner is a nice tank isn't it

Just for future reference the one you showed are Miniature Aircraft USA angled tank fittings.
https://www.miniatureaircraftusa.com/mi ... itting-set

(The Graupner tank 272 is 1ltr) The nalgon bottle is used by several manufacturers.

Thanks Dave.
I managed to get the pic from Google Images but hand idea who did them.
Good for future reference.

Just as an FYI I have some of the Tettra 90 degree fittings too...

I know you are sorted now, but I came across these tanks.

Might prove useful for future reference.

http://www.aeroplusrc.com/ACCESSORIESPR ... duct_id=28

Kev