Postby Dave Lowe » November 25th, 2016, 10:49 pm
Hi Nick,
I've been flying a Hannibal with a 2 piece wing for over two years, Quite easy to do with a tube and a secondary carbon rod towards the trailing edge, I put a split former (1/4 ply ) on the leading edge with 1/2" dowels epoxied in, to act as retainers in the fuz. and 6mm bolts near the trailing edges ( I used furniture bolts), Extend the hight of the rear formers a little (its not critical) Put the wings together and fix to the model, with a layer of polythene on top of the centre section now build a cockpit centre to fill the gap, this can be held in place by strong magnets or screws and gives you access to the wing bolts for removal, You can then hollow out a cockpit and fit a pilot looks a lot better than the pilot just stuck to the top of the wing. Easier to show you than to talk about it so if your ever in Staffordshire give me a ring and call in.