Retract filling valve

[Mike altham]

I am in need of two filling valves but I would like them to be the same as my first one.

It is from Unitracts and just utilises a standard tyre inflator adaptor.

Does anyone know where I cand get these adaptors so I can make my own fill valves

Cheers

Mike

[Rob Buckley]

Mike,

If it's just the standard car type stem, your local tyre fitting place should have a big plie of old ones they've taken out to sell people new ones.

I'm sure they'd let you have a couple

Rob

[Mike altham]

Hi mate

Do they have a threaded end on the other end as I would need to screw it into a ali block

Cheers

Mike

[John Rickett]

Mike,
The Unitract fittings have a festo connector at one end and a Schraeder fitting at the other. By using the supplied nuts the fitting can be fixed to a ply or aluminium plate. Unitracts is still in business, albeit on reduced hours, so couldn't you get the proper things and save yourself some trouble?
Regards
John Rickett

[Rob Buckley]

As I recall, the tyre valves are brass & threaded along their whole length once the moulded rubber is cut off.

I was going to suggest Unitracts, but I though that was a bit obvious & would be bordering on facetious!

Phil Clarke at Fighteraces sells them too.

[John Rickett]

Rob,
When you get to my age, stating the obvious and being facetious bcome natural!

[Rob Buckley]

Saying nuffink...

[Martin Waller]

I have recently bought one from Unitracts.

Martin 1237

[Martin Waller]

I have recently bought one from Unitracts.

Martin 1237

[Mike altham]

Hi guys

Got two from Phil at fighter aces.

Removed the small nipple and the inner of the valve tapped the end 5 mm and fitted a 4 mm festo fitting.

Cheers